The F300 series is a versatile and rugged, high-performance air velocity and air temperature sensor.
The F350 series is a versatile, high performance, air velocity and air temperature sensor where the sensor element is built remotely from the sensor electronics.
The Accu-CT revenue grade, split-core current transformer offers outstanding linearity and phase angle accuracy with a unique one-handed opening and closing mechanism.
The Accu-CT ACTL-1250 series split-core current transformer (CT) offers revenue grade performance with a unique one-handed opening and closing mechanism
The room air quality transmitters QRT 24 series for the measurement of VOC's (Volatile Organic Compounds)
0-300 volt self-powered transformer for monitoring sine wave, single-phase AC voltage. Requires Input Cable for use with U12 loggers.
The Magnelab 300-Volt AC Potential Transformer is used with the FlexSmart TRMS Module to provide accurate measurement of AC voltage.
The Magnelab 600-Volt AC Potential Transformer is used with the FlexSmart TRMS Module to provide accurate measurement of AC voltage.
The CSV-A8 is a split-core AC Current Sensor with adjustable threshold switch output to monitor when equipment turns on and off.
The Advanced Pulse WattNode is a true RMS AC watt-hour transducer with pulse output proportional to kWh consumed. The WattNode provides accurate measurement at low cost to meet your needs for sub-metering, net-metering, energy management, and performance contracting applications.
An Air Differential Pressure Transmitter PTO 500V with output 0-10 Vdc and pressure range 0-500 Pa.
Flexible & Multi Functional Air Differential Pressure Transmitter
RCD 010 THD is a wall mounted transmitter which combines Carbon Dioxide (CO2) + Humidity (rH) + Temperature (T) with a display
The CO2R-series can measure Carbon Dioxide (Co2) ranges of 400-2.000 ppm, 0-2.000 ppm, 0-5.000 ppm, 0-10.000 ppm
The duct CO2 sensor CDK is a maintenance-free, micro- processor-controlled unit designed for duct installation and is used to detect the CO2 content of the air.
The Duct air quality transmitters QDT 24 series for the measurement of VOC's (Volatile Organic Compounds)
The Carbon Dioxide (CO2) + Temperature transmitter CDR 010T is a self-calibrating microprocessor-controlled unit with 2 x 0-10VDC Outputs.
The VCP Carbon Monoxide (CO) Detectors with a measuring range up to 300ppm are suitable for CO measurement in parking garages, tunnels, engine repair shops, loading bays, engine test benches, shelters, go-kart race courses etc.
The small size 5 to 75 AMP split-core AC Current Transformers (CT) are mounted around a current carrying wire to measure AC amperage. This CT provides a 0 to .333 Volt AC output proportional to current flow and are used with Onset loggers.
Split-Core Bi-Polar DC Transducer sensor that measures up to 200 Amps of DC current in both flow directions.
The pHionics STs Series™ pH sensor provides accurate pH and temperature measurements from 0-14pH to a datalogger or RTU for continuous water quality monitoring.
The pHionics STs Series™ Dissolved Oxygen sensor accurately measures dissolved oxygen (0-20 mg/L or percent saturation) and temperature (0-50°C) over long periods of time with little maintenance required.
The pHionics STs Series™ ORP sensor provides reliable ORP (redox) and temperature measurements to a datalogger, RTU, PLC, or SCADA system for continuous water quality monitoring.
Flow measurement of compressed air and gases, with or without display.
The pHionics STs Series™ Conductivity is a water quality sensor designed to pair with a datalogger or RTU for real-time data capture.
The air pressure transmitter PAM 1-series is used for measuring differential pressure, volume flow in air, above-atmospheric or below-atmospheric.
The Intech IN-LLT hydrostatic level transmitter is a fully sealed submersible pressure instrument designed for liquid level measurement.
The AVT Series is a Duct mounted Air Velocity Sensor for HVAC application, with or without LCD Display.