FastCAL 3000 is a high temperature blackbody source with a capacity to produce high temperature using high emissivity emitter(graphite tube) and at the same time stabilize at the required temperature within a few minutes. It is mainly used to calibrate non-contact temperature sensors. Step change in temperature is achievable within seconds. The graphite tube has an emitter diameter of 25mm (1.00″) and an emissivity of +0.995 ±0.005. Target temperature is sensed by a non contact temperature sensor/Pyrometer which gives a feedback to PID controller to regulate the cavity temperature precisely to the desired set points. Remote set point is achieved via RS-232 C communication port. All safety features to protect equipment and operator are easily accessible.

Key Features:

• Water flow failure
• Increase in water temperature
• Argon gas flow failure
• Over current

 

Temperature Range	600°C to 3000°C
Method of Control	PID Controller Eurotherm make 3504
Controlling Sensor	Pyrometer, Make AST AST Model 250
Wavelength	1000 nm or 1600 nm (Pyrometer)
Accuracy	0.3% of the full reading with full span of pyrometer
Temperature Resolution	0.1°C
Emissivity	0.99
Cavity	Graphite Dual cavity blackbody, one side for control and one side for measurement
Heating Aperture	25mm, other size also available as per user request
Cooling	Water cooling system through chiller unit
Purge Gas	Argon gas flow with 10-12 LPM respective
Heating Time	Approx 5 Minute from 600 to 3000°C
Safety Interlocks	Cooling water over temperature, Low purge gas flow, cooling water flow, over current and over temperature protection
Remote Controller	Set Point control and temperature monitoring by RS 232
Ambient Temperature	Ambient +/- 15°C
Power	440VAC, Two Phase AC 50/60 Hz 60KW
Dimension	1570mm (H) x 825 mm (W) x 1200mm (D)
Weight	300kg approx