The Z-2400-A2 series of units support the communication of analogue and digital signals via a wireless link. The series consists of three separate wireless nodes for: Input, Output and Repeating, and does not require a computer to monitor the wireless network. Built on the ZigBee® protocol, this allows for multiple Z-2400-A2 wireless links to operate side by side at the same time.

The Output node is the base and acts as the master for the entire link. The Input node acts as a wireless remote station and seeks for the Output Base to transmit the input signals to. The Repeater node is the bridge between the Input and Output wireless nodes, and is only used when the distance between them is too large to communicate directly.

Note: The Z-2400-A2 Series are used for Stand-alone wireless data links. For MicroScan SCADA wireless data links, the Z-2400 Series are used.

The Z-2400-A2 Series require the XU-USB Programming Key for Software Configuration and uP Programming Software Free download

USB Programming Key for programming Z-2400-A2 Series using uP Configure Programming Software (version 1.2.8.0 or later).

(Same Key as used for programming XU Series transmitters, 2400-A16 / 2400-M-R, Z-2400-Sleeper and IN-uP4.)

Applications:

• Industry
• Energy
• Laboratories
• Blood Banks
• Hospitals
• Agriculture
• Food Storage
• Food Processing
• Water & Waste Water
• Multiple Locations
• Mobile Monitoring

Note: ZigBee® is a registered trademark of the ZigBee Alliance, Inc.